*Using the "Usb Format.exe" - it can't find my flash drive. *cmd prompt: diskpart -> list disk -> select disk 1 -> clean - "DiskPart has encountered an error: The media is write protected." *cmd prompt: diskpart-> list disk -> select disk 1 -> attributes disk clear readonly - I get the message "Disk attributes cleared successfully." However, nothing happens I still get the error "The disk is write protected." whenever I try to do anything. *Going into regedit, finding my StorageDevicePolicies, and setting WriteProtect to 0 - regedit claims WriteProtect is already set to 0. *Going into my flash drives properties and turning off write protection - write protection does not show up under my *flash drives properties. *Checking the flash drive for errors - I get the "The disk is write protected." error. *Formatting the flash drive - I get the "The disk is write protected." error whenever I try this. *Flipping a switch - there is no switch on my flash drive. I've already tried the following methods to get it out of write protection: I'm starting to get frustrated to be honest, because I honestly don't know why it's doing this and I can't find a single person that has ever had this problem to the extent that I do. So it's all good now.I have tried literally everything to get it working and literally nothing is getting it out of write protection. In case you haven't realised it yet, you have to press the Enter key on your keyboard after each command line above.Īnd it looks good in diskmgmt.msc too. list partition (There should still be one).list partition (Inspect the results to double-check this is the right disk).select disk 1 (Careful! Choose the correct number here.Voilà! La Run prompt! L'invite de commande! While still holding the Windows key, press the R key. But if not, just press and hold down the Windows key on your keyboard. I assume you know how to get to the Run prompt since you have arrived at SU. Selecting the incorrect disk might erase your whole computer's main disk drive, losing all your data on it. So here is a run-down of all the commands I used, step by step.īeware that when typing select disk 1 (step 4), your disk number may be different. What I was missing is the command to create a new partition. How do I restore the capacity back to 16 GB-ish (14.9 GiB)? Maybe it is in fact the format operation in Windows that messes things up. Is this a standard routine, like part of the whole "user experience", that whenever you make a bootable USB falsh drive with FreeNAS, it messes up your device? I am new to FreeNAS, so i wouldn't know. So I used the clean option to try to wipe it, but that wiped off everything so it's totally useless now. I tried using diskpart on the 2 GB model, and I saw that there were several partitions there ( list partitions) just like on this one. I thought it was broken there for a while, until I saw the same problem with this 16 GB model. It too was used for FreeNAS, and it too has a reported capacity of only 938 MB. Now, I have another 2 GB USB flash drive with the same problem. So in Windows Explorer now, 938 MB is reported as capacity of this device.Īlso, when i check the properties dialog box I can see the same numbers.Īnd when I check with diskmgmt.msc I can see there are several volumes I don't recognize and unallocated space of 12.79 GB. So I formatted it inside Windows using the format option when prompted. Then later, when I inserted the the USB drive into my Windows 7 computer it said that it had to be formatted, because it couldn't read it. I used the Win32 Disk Imager tool to write the IMG to the device. After writing the FreeNAS IMG to a 16 GB USB flash drive, I can now only use 938 MB.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |